Posts: 227
Joined: Wed Nov 22, 2006 2:49 pm
Location: matrixmultimedia
Thu Mar 20, 2008 3:10 pm
Formula Flowcode program not running after programming
Hardware : HP629 Formula Flowcode Micromouse
------------------------------------------------------------
Symptoms :
----------------
After the micromouse has been programmed it does not immediatley start running the program.
Cause :
----------------
There is a setting in the Formula Flowcode component properties that allows you to wait for a button press so that the micrmouse does not drive off a high surface and become damaged.
Solution :
----------------
Either press one of the buttons on the micromouse to start the program running or disable the wait function by unticking the box in the Formula Flowcode component properties.
------------------------------------------------------------
Symptoms :
----------------
After the micromouse has been programmed it does not immediatley start running the program.
Cause :
----------------
There is a setting in the Formula Flowcode component properties that allows you to wait for a button press so that the micrmouse does not drive off a high surface and become damaged.
Solution :
----------------
Either press one of the buttons on the micromouse to start the program running or disable the wait function by unticking the box in the Formula Flowcode component properties.