Post Thu Mar 20, 2008 3:10 pm

Formula Flowcode program not running after programming

Hardware : HP629 Formula Flowcode Micromouse
------------------------------------------------------------

Symptoms :
----------------
After the micromouse has been programmed it does not immediatley start running the program.

Cause :
----------------
There is a setting in the Formula Flowcode component properties that allows you to wait for a button press so that the micrmouse does not drive off a high surface and become damaged.

Solution :
----------------
Either press one of the buttons on the micromouse to start the program running or disable the wait function by unticking the box in the Formula Flowcode component properties.